Dynalign Golf - The Future of Golf Shot Alignment
Sample Material
Home
Customer Reviews
Purchase Golf Shotmaker Manual
Dynalign Alignment In The News
Read A Sample
Dynalign Blog
Right Touch - Putting Distance Trainer
Golf Book Store
Our Policies
Contact Us
Links

fig3-6pronation-supinationdrawingsnonumber.jpg


The illustration above shows the approximate configuration of the radius and ulna bones in an address position using traditional alignment technique. The leading hand position can vary using either a slightly weaker or stronger grip, but the leading radius and ulna bones will remain crossed. The radius and ulna bones in the trailing arm are uncrossed.

At impact the configuration of the radius and ulna bones in the leading and trailing arms will reverse. The trailing arm bones will become crossed, and the leading arm bones will become uncrossed.

Golfers who use traditional alignment technique must correctly time the change of position in the bones so that the clubface is properly aligned at impact. This is difficult to do with consistency unless you have exceptional hand-eye coordination. Even at the highest skill levels, golfers can fail to correctly time their release. The clubface will be open at impact, resulting in a slice or a push, if the golfer is late in timing the release. If the golfer releases too soon, the clubface will be more closed at impact than anticipated, and result in a hook or pull. Even a slight misjudgment will cause an errant shot.

The Dynalign(tm)pre-shot alignment routine configures the radius and ulna bones of both arms in an impact position before a swing or putting stroke is made. The result of dynamic pre-shot alignment is increased control and consistency over clubface alignment as it will be at impact. The golfer can improve the accuracy of all shots from putting and chipping to full shots.


Pre-putt Routine for Putting vs. Chipping and Full Shots

The pre-putt routine taught for putting is similar to the pre-shot routine for full shots. Putting is the easiest way to start learning how to use the Dynalign Golf Alignment Methodtm because it contains fewer alignment steps than are used for chipping and full shots. The pre-shot routine used for chipping contains additional steps used for low or high chips. The pre-shot routine used for full shots contains additional steps used for draws and fades as well as low and high ball flight.

After becoming familiar with the pre-putt routine, you will more easily learn the pre-shot routine used for chipping. Likewise after becoming familiar with the pre-shot routine used for chipping, you will more easily learn the pre-shot routine for full shots. Greater success will be achieved by starting with the simpler technique applied to putting before moving on to the more detailed routine of full shots.


How The Dynalign Golf Alignment Methodtm Increases Clubface Control

The Dynalign Golf Alignment Methodtm helps stabilize clubface alignment by reducing the potential for rotation of the hands, wrists, and forearms between the address and impact positions. When applied to putting, the method can provide greater stability of the putter head alignment through impact without increased pressure from the hands. Distance control for putting can increase because the hands are no longer required to be the primary source of pressure to reduce putter head twisting

Supination is the term that describes the rotation of the leading hand, wrist, and forearm toward the target. The term can be remembered by thinking of the phrase "holding a cup of soup". Supination allows the leading hand, wrist, and forearm to rotate towards the target until a firm end range is reached. Along with rotation comes variation in clubface alignment. Rotation stops when a firm end range is reached and the hand, wrist, and forearm do not continue to rotate freely. When the club is gripped and the clubface aligned in a position where further rotation is minimized, alignment at address will more closely mirror alignment at impact. The Dynalign Golf Alignment Methodtm describes how to grip the club and align the clubface with the leading hand, wrist, and forearm in a supinated position where rotational variation between address and impact is minimized.

Forearm rotation is still allowed to help provide power, but rotation away from the clubface position at address will be more likely return to that position at impact.

Dynalign Golf LLC 2005 All rights reserved Patent Pending

Back To Our Products

Home


dynalignlogocolor.jpg

Copyright 2004-2008 Dynalign Golf LLC. All rights reserved.